6 Common Mistakes When Repairing Your Phone

6 Common Mistakes When Repairing Your Phone

Today we will talk about some of the most common mistakes repair experts make when repairing mobile phones. We at phonefix will make a list for everyone to see if you have made the same mistake when repairing your phone.

1. Don’t backup phone data

While it's your fault for not doing a thorough backup of all the information on your phone before handing it over to an expert, it's also the responsibility of the expert performing phone repairs to do so.

This will ensure that if anything happens, no matter how far-fetched it is, you'll have a backup so you don't risk losing them.

A mechanical lightning protection transmission data cable is recommended, which can be used for iPhone, iPad, and iPod to realize full data migration and easy data backup.

2. Forgot or installed wrong screws

When repairing a mobile phone, parts need to be removed, and many screws are removed. At this time, we must pay attention to the placement position of the removed screws and the corresponding positions of the screws. 

Some technicians are very careless when disassembling the phone. On the workbench, when they reassembled the phone, those screws were nowhere to be found.

Of course we also have our way to prevent these, which is to put all the screws and other problematic small parts on a magnetic screw plate on which you can mark, stick and separate all the small parts.

3. Not cleaning equipment properly

Cleaning your device after a repair takes some patience, and phone repair services offer one of the most common mistakes in this regard, which if you're not careful can make the internal circuitry prone to failure, ruining your mobile phone repair investment.

4. Do not remove the SIM tray before attempting to remove the circuit board

This one comes from the iPhone, but applies to other phones as well: the slide-out tray where the phone holds the SIM card goes deep into the phone and is usually made of metal.

At least two different teardown engineers told me that while they wrote it into the guide themselves, they often forgot about it until they wondered what was keeping the board from coming out.

5. Unconventional prying can damage tiny components

It only takes a little force to slide a clip or battery compartment onto a small module, now you can't do DIY repairs yourself.

Take your time, and if you're applying pressure and it's not working, always step back and see what's there, check for clips, screws, cables, or anything else that could keep you from losing the object.

6. Disconnect the battery:

The importance of removing the battery before starting the repair is one of the worst mistakes you can make when servicing your own phone. Because there have been many cases of flickering screen issues after phone repairs, leaving the battery connected could damage delicate parts of the phone or cause a short circuit.

When you master these maintenance pitfalls, you can service or repair your appliances with peace of mind. These tips are easy to avoid and should give you the confidence to ensure your phone is as good as new.

You can also check out our website, Phonefix, for the latest phone parts, repair tools, and other tech-related reviews.